Tags :PolyWorks 10

The PolyWorks/Inspector variant differs by requiring that you load the scanned data of your physical part or the nominal MCAD model from which it’s manufactured. An initial best-fit alignment is performed to create a rough alignment. You then use a number of techniques to align it further: as a 321 alignment (where three common points are used to align the two sets), or using geometry references, such as circular features or planes.Once the system has the two datasets aligned, you can see a comparison of points to MCAD data, which is color- mapped to show deviation and adapted to your tolerance requirements. Once you have the view in the state that you want, you then create a SnapShot. This captures...